Motor control Warema type "MSE Kompakt 3 AP"

The motor control unit (MSE) Compact 2/3/4/6 AP is an electronic control device for the potential-based control of up to 6 sun shading drives. The power supply for the MSE and
the drives is 230 V AC. The connected drives can be operated on site using a suitable control element; control via a sun shading control center is also possible.
The 24 V DC control voltage required for this is generated in the MSE itself. Several MSEs can be combined into a group and controlled together.

Function

By flipping a switch on the module, one of the two integrated control programs for the runtime behavior can be activated for 2 motors at a time.
The set runtime behavior always remains effective in pairs, regardless of any group that may have been formed.

Program 1: Local operation with time logic:
This control behavior is particularly suitable for slat products such as external venetian blinds or Venetian blinds: The sun shading moves in the corresponding direction after the button is pressed.
If the button remains pressed for longer than 2.5 seconds, the control system goes into self-retaining mode. The button can then be released. The sunshade moves until the fixed set running time of
Running time of 3 minutes. To cancel the self-retaining function and stop the motor, the button opposite the move command must be pressed briefly. If you only want to turn the slats
you can briefly press one of the buttons.

Program 2: Local operation with permanent logic:
This control behavior is suitable for roller shutters and fabric products, for example: The sun shading moves in the corresponding direction after pressing the local button and immediately goes into
immediately goes into self-retaining mode. The push-button can be released immediately and the sun shading system moves until the fixed running time of 3 minutes has elapsed.
To cancel the self-retaining function and stop the motor, the button opposite the movement command must be pressed briefly.

Central operation:
Local operation is disabled for the duration of a central operation; any pending move command is deleted in the process.

Group formation:
Groups can be formed by looping the button lines through to several button inputs. If the group control line is looped through, it is also possible to
group formation across the motor control units is also possible.